Trekker Ltda.
  Tel:   (+56) 71 197 27 57
  Mobil: (+56) 9 850 162 11

info@trekkerchile.com
skype: trekkerteam

Behind the lift-up tailgate the camper offers enough storage space for all camping equipment and all the other things you can not store inside. In order to open the lift-up tailgate, firstly one needs to open the door with the spare wheel. In the middle of the vehicle at the lower part of the construction there is a leverage, which should be pulled towards you in order to open the door. The spare wheel can be unhooked from the mounting by simply turning the holding device.

The bonnet can be opened with a round hook below the instrumental panel at the driver’s side. Underneath the bonnet in the middle there is a lever which has to be detached in order for the bonnet to be opened. It has to be supported by a rest, which is located beneath the radiator. The rest has to be inserted into the purpose made hole of the bonnet.

   

The vehicle has four doors; the driver’s door as well as the passenger’s door can be opened and closed in the usual manner. The sliding door at the passenger’s side has to be opened form the outside by the leverage at the left side. If you open the door completely it will snap in and can not be closed by itself. To close the door, kick the knob in the lower guide bar. To open the folding door in the back the right side of the door has to be opened first, in order to open the left one as well, pull the black leverage out. Both doors can be closed when pressing the leverage in so that it snaps.

   

 

Please do always detach the control element of the radio when leaving the car. At the upper right side there is a button which has to be pressed to loose this control element. Please insert the radio into the proper box and store it either in the compartment for glasses or in the glove department. Here you can also find the manual for the radio as well as for the vehicle. The handling of the car radio with integrated CD player is quite easy and works just like any other radios. Please refer to the manual for in-depth information.

The caravan has different storage spaces inside of the camper. They can easily be opened by pressing a button and pulling the cover at the same time. When closing the cover it will snap in again. Below the settees additional storage space can be found.

 

The storage tank for the windscreen wiper fluidity is located under the bonnet and can be easily spotted by the blue sealing lid. Clean tab water with a bit of dishwashing detergent can be used as fluidity.

The battery of the camper is located on the passenger’s side under the bonnet. The power of the battery is as well used for starting the vehicle as for using the light in living arrangement. The battery is quite powerful and can be used to an adequate extend to support the camper with electricity. Above the battery sits a turning wheel, with which one can turn off the complete power supply. This device is also a protection against theft.

The table can be easily installed while driving. In case the seating arrangement should be used as bed, attach the table top in-between the settees and use it as base of the bed. Firstly, open the Velcro fastener of the outside of the settees and simply lift them. At the upper part of the tight hollow there is a steel frame, which can be detached by quick clamps. Pull these frames back so that the clamps snap back in again. The table can be unhooked at the rear wall facing in driving direction. Unscrew the table-leg, so that you can turn it down to the front. Now you can arrange the cushion pads on it, so the sleeping area is complete.

The two gas bottles each of which contain 5 kg of gas (or alternatively a 11 Kg bottle) are stored behind a little door labelled GAS on the passengers side. There is a sliver lid with a switch lever on top of the bottles used to open the gas pipe. For cooking it is necessary to open the pipe, while driving the pipe has to be closed again.

Changing the gas bottles:

In order to exchange the bottles the silver lid has to be removed. After exchanging the bottles the lid has to be attached to the new bottle. In case the spare bottle is empty one can purchase new ones at every petrol station. If one is not exactly sure how to exchange the bottles, one should ask the shop assistant for help. As the use of gas is no longer common in Europe each customer will receive detailed instructions on how to operate it correctly.

The gas stove disposes of three levels: off – min – max. Min indicates a small flame and max an accordingly big flame. Out of security reasons the gas does not flow if one only positions the knob to min or max, it only flows when the knob is pressed. Now the stove can be lightened by match or lighter. Keep the knob pushed for several seconds, so the flame does not die. Should the flame lapse due to wind, the gas supply will be cut off automatically after 15 seconds. When using the gas stove in the kitchen make sure there is aeration, it might be a good idea to keep the sliding door opened. Furthermore one can also active the electrical ventilation in the roof. The aerating pipe can be opened when pushing up the leverage; it can be adjusted by turning the knob.

   

The auxiliary heating system (see image 11a) can be switched on by the turning knobs. The right knob should be in the position of Pilot; the left knob next to it should be pressed at the same time. This causes a spark which will ignite the gas. A tiny blue flame is visible through a panel just above the turning knobs (see image 11b). One needs to press the right turning knob for several seconds so that the flame will not die immediately and has then be turned to the position HEATING (see image 11c)

The slide bar of the shower is located under the bed above the driver’s cabin. It should be attached outside at the drivers side at a metal appliance including the shower curtain (see image 56). The solar shower can be filled with warm water and fastened at the vehicle.

There are two tanks for the camper, one behind the driverscabin for storing clean water i.e. water for kitchen and cleansing use. The second one is on the passengers side is for storing the dirty water.

Refilling the tank:
On the driver’s side there is an opening labelled Wasser/Agua (see image 4). The water has to be filled in by pipe or can.

Emptying the tanks:
Both tanks have a screw cap, which when opened allows the water to drain out (see image 4b and 5). The vehicle should be parked on an ascent; the driver’s cabin has to be higher as the back of the vehicle; in order to speed up the process.

This appliance has, besides measuring the air pressure and pumping up the tires (see tyre pression), many other functions. It can also be used as “starter” in case the battery is empty, one does not need another vehicle in order to start the car. To make a so called “jump start” one should follow the steps below:
1: attach the red (+) “Alligator” clamp to the red (+) positive battery station of the car.
2: attach the black (-) “Alligator” clamp to a non movable metal part of the motor and NOT to the (-) negative battery station.
3: wait for a minute or two
4: start the motor for approximately 5 to 6 minutes
5: should the motor not start, wait at least three minutes and try again.
Pay attention that the black and the red clamps will not get in contact with each other under any circumstances.
1: if the motor is running, detach the black (-) clamp first and store the cable.
2: detach the red (+) cable and store it
3: connect the “Power Booster System” as quickly as possible to the 230V adapter and charge it.

The jumper cable for a possible emergency start is located behind the settee inside the driver’s cabin. In order to bridge the battery of a second vehicle it is essential that the two positive and negative poles of the vehicles are connected. The motor of the helping vehicle should be running with an increased revolution speed for several minutes just before the first start attempt.

The tow rope is stored behind the settee of the drivers’ cabin. In case the vehicle needs to be towed away, the bolt of the rope should be hooked into the towing apparatus in front at the right side below the bonnet. Careful: the brake amplifier is not working when the motor is running.

The spare tyre of the vehicle is located behind the trunk door, the tools therefore can be found in the trunk at the left side. Please secure the vehicle by setting up the breakdown triangles, before changing the tyre. First of all remove the protective cap of the wheel rim, and then loosen the wheel lightly with the screwdriver before lifting it with the car-jack to its full extension. Attach the car-jack to the vehicle only at the marked point; lift the vehicle with the crank handle. The car-jack should be in a firm straight position, furthermore a gear has to be inserted and the handbrake should be activated. When the car is lifted you can loose the screws of the wheel and disconnect the wheel. Do not lie down under the lifted vehicle. The spare wheel can now be disconnected with a screwdriver; the damaged wheel then takes its place. The spare wheel has to be fixed to the vehicle by lightly tighten the screws, do not tighten these in one go, instead tighten each screw in several goes. Make sure that they are tightly screwed and after a couple of kilometres repeat this process. After the exchange has taken place, please attach the protective cap to the wheel.

   

 

In order to check the oil level do open the bonnet. The bonnet can be opened with a round hook below the instrumental panel at the driver’s side. Underneath the bonnet in the middle there is a lever which has to be detached in order for the bonnet to be opened. It has to be supported by a rest, which is located beneath the radiator. The rest has to be inserted into the purpose made hole of the bonnet. Next to the motor block there is a yellow ring, do push this ring up to loosen the oil dip stick. The car should be parked for several minutes, otherwise the measurement of the oil level is not that precise. Pull the yellow ring out and wipe the oil off. Insert the dip stick as far as it will go and take it out again, now you can read off the oil level. One part of the dip stick is rippled, the oil level should in this array, if not fill some more oil in. To do so unscrew the lid with the image of an oil can on the motor. After refilling it, please check the oil level gain. In case you have filled in too much oil, when the oil is above the rippled art, please do go to a repair shop so the excessive oil can be drained. Trekker Ltda. maintains the vehicles every 5000 kilometres, the exchange of oil and oil filter are enforced. This service is possible in every authorised Nissan repair shop, costs arising from this will be refunded by Trekker Ltda.

The tyre pressure can be checked with a so called “jump start with air compressor”. Behind its cover is a small hose with a valve-adapter. This one has to be fixed to the valve of the tyre, on the dial gauge one can read the tyre pressure (measured in Libras). At the push of a button (black button) one can fill in more pressure. The tyre pressure can also be checked with a small gauge. The ideal tyre pressure for the tyres in front is 32l and for the ones in the back 65l.